Microplex logiJET T4-2 - Page 42

42 Handling of Consumables
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual logiJET T4-2 /T6-2 /RFID Edition 2.2
3. Push the adjusting ring of the ribbon supply shaft towards the
ribbon roll.
4. Then turn the adjusting ring of the ribbon supply shaft
clockwise to increase the ribbon tension, while you hold
the ribbon roll with the other hand.
Fig. 5.3.2.a Adjusting the ribbon tension at the ribbon supply shaft
5. Check that the ribbon has no folds and is running straight.
Optimize your adjustment of the ribbon tension, if need be.

Check to see that slack and wrinkles on the ribbon are removed
completely. Do not be afraid to ’waste’ a little extra ribbon to
ensure the ribbon is running correctly and wrinkle-free.


Adjusting ring
Mantenimiento Periféricos Informáticos C/Canteras, 15 28860 Paracuellos de Jarama (Madrid) Tel: 00 34 917481604 Web: https://mpi.com.es/