6 Contents
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual logiJET T4-2 /T6-2 /RFID Edition 2.2
Chapter Page
9.30. Selecting the Tear Off Mode (Option: Cutting Mode) 134
9.31. Selecting the Print Mode 136
9.32. Adjusting the Tear Off Position (Option: Cutting Position) 139
9.33. Configuration of Network Parameters (IP Address, e.g.) 141
10. Using the RFID Functions 145
10.1. Integrated RF Write/Read module 145
10.1.1. CE - Conformity 145
10.2. RFID Panel Functions 147
10.2.1. Selecting the RFID Mode 147
10.2.2. Selecting the Communication Protocol 148
10.2.3. Adjusting the Transponder Position (Tag Position) 149
10.2.4. Adjusting the Number of RFID Access (Timeout) 155
10.2.5. Adjusting the Transmission Speed (Bit Rate) 156
10.2.6. Reading the Label Identification Number automatically 157
10.3. Data Interface Status Out 158
10.4. IDOL Commands for RFID 159
10.4.1. Overview Function Group RFID 159
10.4.2. Reading the Label ID Number (Prior to the Print Process) 162
10.4.3. Writing Data into a Data Block of the RFID Label 163
10.4.4. Generating a Page ID Number, Receiving the RFID data after Printing 164
10.5. Syntax of RFID Data (Status Messages) 166
10.6. RFID Errors 168
11. Operator Maintenance 173
11.1. Printer Cleaning 173
11.1.1. Printer Cabinet Cleaning 174
11.1.2. Printhead Cleaning 175
11.1.3. Transport Roller Cleaning 178
11.2. Printhead Exchange 179
11.2.1. Printhead Removal and Installation 180
11.3. Adjusting the Right Pressure Value 184
Mantenimiento Periféricos Informáticos C/Canteras, 15 28860 Paracuellos de Jarama (Madrid) Tel: 00 34 917481604 Web: https://mpi.com.es/
To Next Page
Loading...
