Printer Configuration and Menu Structure 75
________________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual logiJET T4-2 /T6-2 /RFID Edition 2.2
Functions / Changing of function values:
Within one function the value can be changed by pressing the key
NEXT or PREVIOUS.
In case of a multi-digit function value pressing the NEXT key switches
to the next position of the function value. Pressing the PREVIOUS key
switches to the previous digit of the function value.
Please note: If you press the PREVIOUS key although the absolute left
digit of the function value is still arrived, the changing
procedure will be cancelled and this moves you to the
next menu level above.
If you press the ENTER key although the absolute right
digit (digit 1) of the function value is still arrived, the
currently displayed function value is stored.
In case of a multi-digit function value the value of the currently chosen
digit will be changed via the UP and DOWN keys. Press the UP or
DOWN key to increase or decrease the value.
By pressing the ENTER key the function values currently displayed
are confirmed respectively the selected function is activated (the
changes are saved until the next printer power off; this kind of
saving is called temporary).
After this you have to decide, if you want to save the changes
permanent (Save as setup).
To select such changes permanently, the user must press the ENTER
key one more time. These permanent changes in printer
configuration are active each time the printer is turned on again.
If the ONLINE key is pressed instead, the changes are only stored
temporary (not saved as setup).
(This key takes the user to the respective previous menu level).
Mantenimiento Periféricos Informáticos C/Canteras, 15 28860 Paracuellos de Jarama (Madrid) Tel: 00 34 917481604 Web: https://mpi.com.es/
To Next Page
Loading...
