Microplex logiJET T4-2 - Page 89

Panel Functions 89
________________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual logiJET T4-2 /T6-2 /RFID Edition 2.2
9.3.2.2. Example
Adjusting the printer to the currently used media (Paper Type) is described
in section 9.2. The following example describes the steps of the automatic
sensor adjust of the Gap Sensor (transparent sensor).
Panel display
[ON LINE ]
[OFF LINE ]
[Menu Level 1 ]
  
[Engine ]
[Printspeed ]
  
[Sync. Menu ]
[Auto.Sens.Adj. ]
[Load Label ]
[Load Backing ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this key.
The ENTER key gives the user access to
the menu structure.
Press the NEXT or PREVIOUS key until
[Engine ] is displayed.
Press the ENTER key, this selects the
Engine menu.
Press the NEXT or PREVIOUS key until
[Sync. Menu ] is displayed.
Press the ENTER key, this selects the
Sync.Menu.
Press the ENTER key, this starts the
automatic sensor adjust.
Open the printhead and place label
(with masking paper) in the sensor area.
Close the printhead.
Press ENTER: the printer automatically
measures the contrast value.
Open the printhead and place (only) the
masking paper in the sensor area.
Close the printhead.
Press ENTER: the printer automatically
measures the contrast value.
In addition this new value can be saved
as setup value (using the ENTER key).
After this decision turn the printer
ONLINE again: Press the ONLINE key
longer than 2 seconds.
Mantenimiento Periféricos Informáticos C/Canteras, 15 28860 Paracuellos de Jarama (Madrid) Tel: 00 34 917481604 Web: https://mpi.com.es/