Miller OptX 2kW - Personnel Qualifications; Professional Qualification; Product Specific Qualification

Overview
19
OM-296747A | 4/15/24
1.4 Personnel Qualifications
The areas of responsibility, ensuring the necessary competence and supervision
of personnel must be precisely regulated by the product owner.
The personnel assigned to install, operate, and maintain the product must have
the corresponding qualifications for performing this work. Any lack of knowledge
on the part of the personnel must be corrected through training and instruction.
1.4.1 Professional Qualification
Professional qualifications are a necessary prerequisite for certain work on the
product. Depending on the respective work, the corresponding product-specific
qualification is also required.
Electrician
Electrical specialists include professionally trained personnel with the appropriate
knowledge and experience. They are permitted to carry out electro-technical work,
to assess it and recognize any potential hazards involved.
Laser Safety Officer
Laser Safety Officer include professionally trained personnel with the appropriate
experience and qualification. They are responsible for conformance and enforce-
ment of laser safety regulations. Successful participation in the training must be
confirmed by an examination certificate. For further information please follow the
local regulations.
1.4.2 Product Specific Qualification
Product-specific qualifications are obtained during training and instruction on the
product. Depending on the product-specific qualification acquired, personnel are
divided into the following groups:
Operating Personnel
The operating personnel was trained and instructed in the safe operation of the
product.
The operating personnel may only:
• Perform welds using preset programs
• Perform cleaning using preset programs
Advanced Operating Personnel
The advanced operating personnel may
• Create User Mode recipes (welding/cleaning programs)
• Adjust preset welding and cleaning programs
• Select and install the torch nozzle tip and tube
• Set up global device parameters
Maintenance Personnel
The maintenance personnel is made up of staff who have the corresponding
professional and product-specific qualifications to perform the tasks listed below.
The maintenance personnel are trained in the maintenance of the product by
Miller or another responsible Miller subsidiary or authorized to carry out the
maintenance work, insofar as this is not carried out by employees of Miller.
The following tasks are performed by the maintenance personnel: