Preface
6
OM-296747A | 4/15/24
Preface
Ensure you read and understand this guide in its entirety and familiarize yourself
with the operating and maintenance instructions before you use the product.
Miller strongly recommends that all operators of the product read and pay
particular attention to all safety information contained herein prior to oper-
ating the product.
For product technical assistance, contact Miller Customer Service.
Miller Electric Manufacturing Co.
1635 W. Spencer St.
P.O. Box 1079
Appleton, WI 54912-1079
Tel: +1-866-931-9730
Email: PWSService@millerwelds.com
www.millerwelds.com
Audience
This guide is intended for all owners and operators of the OptX system, as well as
all persons working in the vicinity of the product when it is in use. Use of this
product should be limited to fully trained industrial, professional or commercial
operators who are responsible for welding in industrial and non-industrial instal-
lations for commercial purposes.
All users of this product must be trained in both welding and laser safety,
and must follow all instructions and safety warnings in the Owner’s Manual,
safety labels on the
OptX system, and all applicable safety standards, laws
and regulations, including:
In the United States:
• ANSI Z136.1 - American National Standard for Safe Use of Lasers
ANSI Z49.1 - Safety in Welding, Cutting, and Allied Processes
You can obtain a copy of the safety standards through the ANSI webstore at:
https://webstore.ansi.org/
• OSHA, Occupational Safety and Health Standards for Food and Drugs, Title 21 Code
of Federal Regulations (CFR) Chapter I, Subchapter J, 1040.10 Laser products.
OSHA, Technical Manual (OTM), Section III: Chapter 6, Laser Hazards
You can obtain a copy of the OSHA standards at:
http://www.osha.gov/
IMPORTANT
This Owner’s Manual should stay with the product to provide you and all
future operators, users, and owners of the product with important operat-
ing, safety and other information. It should be referred to regularly.
To Next Page
Loading...
