Safety and Compliance Information
40
OM-296747A | 4/15/24
2.3 Regulatory Compliance
The OptX product is designed and engineered with important safety features and
performance and complies with applicable standards and specifications in accor-
dance with governmental requirement.
WARNING
Risk of injury due to illegible or missing labels
Over time labels can become dirty and illegible due to wear, tear or fading. If labels
are illegible, hazards cannot be recognized and necessary operational instructions
cannot be determined or followed, resulting in potential injuries to personnel and
damage to equipment.
Always keep the labels in good condition so they remain legible.
Never remove any of the labeling affixed onto the product.
If any label is damaged, illegible or missing, contact Miller Service (refer to section
B.1 [▶171]) for replacement.
▼Table 10. Compliance Standards Listing
Standard Title / Description
Directives:
2014/35/EU The Low Voltage Directive covers all electrical equipment and components
designed for use with a voltage rating of between 50 and 1000 V for alternating
current (AC) and between 75 and 1500 V for direct current (DC). It provides the
essential (safety) requirements that electrical equipment and components
covered by it must comply with, and it outlines the conformity assessment
procedure the manufacturer must apply in order to ensure compliance with the
essential requirements.
2014/30/EU
1
The EMC Directive aims to ensure that any electrical and electronic equipment
minimizes the emission of electromagnetic interference that can influence other
equipment. The directive also requires equipment to be able to resist the
disturbance of other equipment.
Electromagnetic Compatibility (Emissions and Immunity):
1
IEC 61326-1
(EU)
Electrical equipment for measurement, control and laboratory use - EMC
requirements - Part 1: General Requirements
IEC 61000-6-2
(EU)
Electromagnetic Compatibility (EMC) - Part 6-2: Generic Standards - Immunity
Standard for Industrial Environments
IEC 61000-6-4
(EU)
Electromagnetic Compatibility (EMC) - Part 6-4: Generic Standards - Emission
Standard for Industrial Environments
Class A (Digital Device):
1
47CFR15 Sub-Part B FCC
(US)
Code of Federal Regulations (CFR) - Title 47. Telecommunication - Chapter 1.
Federal Communication Commission - Subchapter A. General - Part 15. Radio
Frequency Devices
ICES-003
(Canada)
Information Technology Equipment (ITE), including digital apparatus - Limits and
Methods of Measurement
To Next Page
Loading...
