Miller OptX 2kW - Table 9 Safety Label Description and Location

Safety and Compliance Information
36
OM-296747A | 4/15/24
▼Table 9. Safety Label Description and Location
1. Identification Plate Label
Rear panel of the device. (Products Made in the US) - See Figure 3 [▶ 39].
2. Laser Radiation Hazard Label 3. Aperture Label (Laser Torch)
Located near output aperture or exit point from the enclosure: (1) rear
panel of the device, (2) top and sides of torch, (3) base of fiber cable
output connector. See Figure 3 [▶ 39] and Figure [▶ 39].
Located near output aperture on
top of the handheld torch.
See Figure 3 [▶ 39].
4. Primary Laser - Laser Class Label (Device) 5. Guide Laser - Laser Class Label
(Device)
Identifies the laser classification for the primary fiber laser used for
material processing. It warns the operator of a laser radiation hazard.
The operator must avoid exposure of the eyes or skin to direct or
scattered radiation. Located on the rear and side of the unit. This label
is specified in English, French and Spanish. See Figure 3 [▶ 39].
Identifies the laser classification for
the guide laser used for positioning
torch nozzle on part. It cautions the
operator to avoid eye exposure.
Located on rear panel of the device.
This label is specified in English,
French and Spanish. See Figure 3 [▶
39].
NE120429L
208-240 VAC
SINGLE
50/60 Hz
32 A
40 A
LASER WELDER OptX 2kW
OX2R32403012U
MARCH 2024
USA
SERIAL NUMBER:
VOLTAGE:
PHASE:
FREQUENCY:
FULL LOAD CURRENT:
MAXIMUM BREAKER SIZE:
DESCRIPTION:
LOT NUMBER:
MANUFACTURE DATE:
C.O.O.: