Safety and Compliance Information
41
OM-296747A | 4/15/24
2.3.1 Class A Digital Device
This equipment is tested and complies with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules and Canadian ICES-003 when marked as such
on the product. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environ-
ment. Modifications of this product could result in non-compliance with FCC rules.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with this guide, can cause harmful interfer-
ence to radio communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the users are required to
correct the interference at their own expense.
2.3.2 Electromagnetic Compatibility
Compliance with the EMC requirements is certified by the CE mark when marked
as such on the product. The European requirements for Electromagnetic Compli-
ance are specified in the “EMC Directive.” Conformance to the “EMC Directive” is
achieved through compliance with the harmonized standards.
Electrical Safety:
EN/ISO 61010-1
(EU)
Safety Requirements for Electrical Equipment for Measurement, Control, and
Laboratory Use - Part 1: General Requirements
Laser Safety:
IEC 60825-1 (EU) Safety of Laser Products - Part 1: Equipment Classification and Requirements
CDRH 21 CFR 1040.10
(US)
Code of Federal Regulations (CFR) - Title 21. Food and Drugs - Chapter I. Food and
Drug Administration - Department of Health and Human Services - Subchapter J.
Radiological Health - Part 1040. Performance Standards for Light-Emitting
Products - Section 1040.10. Laser Products
Worker and Workplace Safety Regulations:
29 CFR (US) Code of Federal Regulations (CFR) - Title 29. Labor. Subtitle B - Regulations Relating
to Labor - Chapter XVII - Occupational Safety and Health Administration (OSHA),
Department of Labor
OSHA Occupational Safety and Health Standards for Food and Drugs, Title 21 Code of
Federal Regulations (CFR) Chapter I, Subchapter J, 1040.10 Laser products.
OSHA Technical Manual (OTM), Section III: Chapter 6, Laser Hazards
1.
when marked as such on the product
▼Table 10. Compliance Standards Listing (Continued)
Standard Title / Description
To Next Page
Loading...
