Miller OptX 2kW - Figure 4 Torch Angle, Reflections and Viewing Position

Safety and Compliance Information
47
OM-296747A | 4/15/24
▼Figure 4. Torch Angle, Reflections and Viewing Position
Laser Beams can reflect from multiple
surfaces. Always be aware of the potential
for multiple reflections during welding.
Improper Torch Positioning Angle
Lower power density radiation scattered from the process zone can travel
certain distances. Within the Ocular Hazard Distance, the scattered radiation
can be dangerous to the eyes. At very short distances the scattered radiation
can also be dangerous for the skin.
Always hold the OptX Laser Torch at an
angle between 30 and 70 degrees.
Always maintain viewing position at
least 20 inches (500 mm) from the
weld seam and behind reflection
zones.
High power density specular
reflections can travel large distances
and can be dangerous for the eyes and
skin.