Miller OptX 2kW - Overview Task; Qualification

Overview
20
OM-296747A | 4/15/24
• Assembly and installation
– Setting up the Laser Controlled Area
– Set up and install the product
– Run lines and fibers to the product
– Connect the product (the power supply must be connected by an
electrician)
– Decommission the product
• Maintenance Work
– Replace protective window
– Replace focus lens
– Clean the fiber cable terminator (quartz block of the fiber connector)
– Replace the torch
• Troubleshooting
– Run diagnostics
– Troubleshooting as described in the manual (refer to chapter 10
[▶153])
1.5 Overview Task / Qualification
Task Chapter in the Manual Qualification
Operating Laser Welder Device:
• Welding and cleaning using preset
programs
5.9 [▶90] System Startup
5.10 [▶91] System Shutdown
7.4 [▶112] Quick Start Welding Using Preset
Programs
7.5 [▶115] Quick Start Cleaning Using Preset
Programs
Operating
Personnel
Operating Front Panel Controls:
• Set up laser power, wobble
frequency, wobble length
• Select and use program mode
recipe
• Set up global device parameters
6.1 [▶93] Rotary Control Knobs
6.2 [▶94] Program Mode Recipe Selection
Buttons
6.3 [▶96] Device Front Panel Setup Mode
Advanced
Operating
Personnel
Operating Laser Welder:
• Select and install torch nozzle tip
and tube
7.3 [▶107] Torch Nozzle Tip and Tube Advanced
Operating
Personnel
Setting program recipe s and
parameters
8 [▶119]. Program Recipes and Parameters Advanced
Operating
Personnel
Setting up
• global device parameters
• program recipes and parameters
9 [▶127]. Computer Connection to Device Advanced
Operating
Personnel