Safety and Compliance Information
37
OM-296747A | 4/15/24
6. Primary Laser - Class 4 Information Label
Identifies the output power, peak power, pulse duration, pulse repetition rate and wavelength range for the
primary fiber laser used for material processing. Located on rear panel of the device. This label is specified
in English, French and Spanish. See Figure 3 [▶ 39].
7. Red Guide Laser - Class 2M Information and Warning Label
Combination label for the guide laser that is used to position the torch nozzle on the part. This label identifies
the output power and wavelength range. It also specifies the classification and warning. Located on rear panel
of the device. This label is specified in English, French and Spanish. See Figure 3 [▶ 39].
8. FDA Certification Label
Located on rear panel of the device. This label is applicable for both the primary and guide laser. This label
is specified in English, French and Spanish. See Figure 3 [▶ 39].
9. When Panel Open Label
Located on device side panels near bottom. This label is specified in English, French and Spanish. See Figure
3 [▶ 39].
10. Laser Class Label (Laser Torch)
Located near output aperture: Left and right side of the laser torch boot. See Figure 3 [▶ 39].
▼Table 9. Safety Label Description and Location (Continued)
To Next Page
Loading...
