Milnor MilTouch - Page 18

16
Pellerin Milnor Corporation
Steam Error (Avoid modification) — Select the time allowed for the machine to use steam
to achieve the programmed bath temperature before the controller issues an error. See Section 4.3
: Errors, page 49 for more information.
Fill Error (Avoid modification) — Select the time allowed for the machine to achieve the de-
sired water level before the controller issues an error. See Section 4.3 : Errors, page 49 for more
information.
Cooldown Error (Avoid modification) — Select the time allowed for the machine to com-
plete a cooldown to a programmed bath temperature before the controller issues an error. See Sec-
tion 4.3 : Errors, page 49 for more information.
Extra Water (Avoid modification) — Select whether this machine is attached to a reuse
water source.
Reuse Drain (Avoid modification) — Select whether this machine has a second drain valve
that discharges to a reuse water reservoir.
Overhead Tank (Avoid modification) — Select whether this machine has an overhead tank.
Flow Meters (Avoid modification) — Select whether this machine is equipped with flow
meters to measure incoming water.
Tilt Type (Avoid modification) — Select whether this machine is a hydraulic-tilt, air-tilt, or
non-tilting machine.
RPM Control (Avoid modification) — This decision must remain at the factory setting, ex-
cept in the case of a retrofit. If this is the case, a Milnor
®
technician will advise you accordingly.
Recirculation (Avoid modification) — Select whether this machine has the equipment re-
quired to recirculate bath liquor.
RinSave
®
(Avoid modification) — Select whether this machine is provided with the Rin-
Save
®
feature.
AmpSaver (Avoid modification) — Select whether this machine is part of a Milnor
®
AmpSaver system to help reduce peak electricity consumption.
Temperature Probe (Avoid modification) — Select whether this machine has a temperature
sensor. A temperature sensor allows programming a specific temperature for each bath step.
NOTE: The machine must have a temperature sensor to use steam or cooldown.
Configuration