Milnor MilTouch - Page 20

18
Pellerin Milnor Corporation
Bath Level Offset (Avoid modification) — Enter the digital counts value required to cor-
rectly display the bath level on the Run display. The correct value (as set at the Milnor
®
factory)
is extremely important to obtain the expected machine function.
Chemical Valves (Avoid modification) — Enter the number of chemical valves controlled
by this machine.
Drain Washout (Avoid modification) — Enter the number of seconds for the drain washout
time.
Name — Give this machine a name. If the machine is connected to a Mildata
®
network, the
name of the machine appears on printed reports.
Simulator (Avoid modification) — Select YES if this software is running on a personal com-
puter. Select NO if this is a washer-extractor.
Counts Per 100 — Currently not used on MilTouch-EX™ WTB machines.
Offset Valve Time — Currently not used on MilTouch-EX™ WTB machines.
Jog Speed (Avoid modification) — Enter the cylinder speed in RPMs when the operator is
manually jogging the cylinder.
Tank Temperature — Not used on MilTouch-EX™ WTB machines.
Programmable Outputs — Currently not used on MilTouch-EX™ WTB machines.
Mildata
®
— Select whether this machine is part of a Mildata
®
network. This decision provides
access to 10 optional decisions for additional Mildata
®
network communications.
Contact Milnor
®
Customer Service/Technical Support using the contact information in Section
6.4 : How to Contact Milnor
®
, page 117 for more information on the Mildata
®
product.
• Address—Enter the machine address on the Mildata
®
network.
• Formula—Select whether this machine will pass formula data for each load to the Mildata
®
computer.
• Work Order—Select whether this machine will pass the work order for each load to the Mil-
data
®
computer.
• Goods Code—Select whether this machine will pass the goods code for each load to the Mil-
data
®
computer.
• Customer—Select whether this machine will pass the customer code for each load to the Mil-
data
®
computer.
• Employee—Select whether this machine will pass employee data for each load to the Milda-
ta
®
computer.
Configuration