Revision:1.0(2023-01-12)
198
2. Use cutting pliers to cut off the cable tie that fixes the power signal cable of the speaker, and
remove the 2 small Phillips pan-head screws on the left and right sides of the speaker.
1 2
Phillips pan-head screw (M4)
2 2
Phillips pan-head screw (M4)
3. Remove the two speaker spacers on the left and right sides, remove the speaker, and remove
the two speaker sleeves on the left and right sides. Be careful not to lose the speaker sleeves.
1 Speaker
7.3.3 Commissioning and Verification
None
Diagnostic Ultrasound System
Service Manual
7 FRU Replacement
To Next Page
Loading...
