Mindray uMEC15 - Setting Up Graphic Trends Reports; Setting Up Realtime Reports; Printer Statuses

21-4
 [Report Format]: If you select [Time Oriented], the report will be printed by time. If
you select [Parameter Oriented], the report will be printed by parameters.
 [Select Parameter >>]: from the popup menu, you can:
 [Currently Displayed Trended Parameters]: print the parameter trend data
selected from the [Tabular Trends].
 [Standard Parameter Group]: select the standard parameter group for printing.
 [Custom]: You can define a parameter group for printing from the parameters
displayed in the low part of the menu.
21.6.3 Setting Up Graphic Trends Reports
To set up graphic trends reports, select [Main Menu]ė[Print Setup >>]ė[Graphic Trends
Reports >>]. As setting up graphic trends reports is similar with tabular trends reports, you
can refer to the 21.6.2 Setting Up Tabular Trends Reports for details.
21.6.4 Setting Up Realtime Reports
To set up realtime reports, select [Main Menu]ė[Print Setup >>]ė[Realtime
Reports >>].
 [Sweep]: set the wave print speed to 12.5 mm/s, 25 mm/s, 50 mm/s, or Auto.
 [Select Wave >>]: from the popup menu, you can:
 [Current]: select the currently displayed waves for printing.
 [Select Wave]: select the desired waves for printing.
21.7 Printer Statuses
21.7.1 Printer Out of Paper
When the printer runs out of paper, the print request will not be responded. If there are too
many print jobs that are not responded, a printer error may occur. In these cases, you need to
install paper and then re-send the print request. Restart the printer if necessary.
Therefore, you’d better ensure that there is enough paper in the printer before sending a print
request.