3-12
WARNING
z Before entering night mode, confirm the settings of brightness, alarm volume, QRS
volume, and key volume. Pay attention to the potential risk when the setting value
is a bit low.
3.11.3 Privacy Mode
Privacy mode is only available when a patient who is admitted at a patient monitor is also
monitored by the central station.
To activate the privacy mode, select [Main Menu][Screen Setup >>][Privacy Mode].
The patient monitor behaves as follows as soon as the privacy mode is activated:
 The screen turns blank and [Under monitoring. Press any key to exit the privacy
mode.] is displayed.
 Monitoring and data storing continue but patient data is only visible at the central
station.
 Alarms can still be triggered. But all audible alarms are suppressed and the alarm light is
deactivated at the patient monitor.
 All system sounds are suppressed, including heart beat tone, pulse tone, all prompt tones,
etc.
To cancel the privacy mode, press any key.
The patient monitor exits the privacy mode automatically in one of the following situations:
 The patient monitor disconnects from central station.
 The alarm [Battery Too Low] or [System will shut down soon. Please replace the
batteries or use the external power.] is presented.
The touchscreen is locked automatically in the privacy mode.
WARNING
z During privacy mode, all audible alarms are suppressed and the alarm light is
deactivated at the patient monitor. Alarms sound only at the central station.
To Next Page
Loading...
Need help?
General
