4-5
WARNING
z Do not discharge a patient before the patient is successfully transferred.
z After a patient is successfully transferred, check if the patient settings (especially
patient category, paced status and alarm limits settings, etc) on the monitor are
appropriate for this patient.
NOTE
z The system automatically switches on the HR alarm and lethal arrhythmia alarm
after transferring the patient data.
z Tranisferring data via USB drive is only avaiable for the monitor configured with a
storage card.
4.4.1 Transferring Data from the Monitor to a USB Drive
1. Select [Main Menu][Patient Setup >>].
2. Select [Transfer to Storage Medium]. In the popup menu, select [Ok].
3. Wait until the following message appears: [Transfer to storage medium successful.
Please remove the USB drive.].
4. Remove the USB drive from patient monitor.
4.4.2 Viewing Data on the Monitor via USB Drive
You can view patient data on the monitor via USB drive without transferring data.
1. Connect the USB drive to the destination monitor.
2. Select [Main Menu][Patient Data >>][History Dat].
You can also select [Patient data in U disk] to view history data if the monitor is configured
with a storage card.
To Next Page
Loading...
Need help?
General
