1-3
1.1.2 Cautions
CAUTION
z To ensure patient safety, use only parts and accessories specified in this manual.
z At the end of its service life, the equipment, as well as its accessories, must be
disposed of in compliance with the guidelines regulating the disposal of such
products. If you have any questions concerning disposal of the equipment, please
contact us.
z Magnetic and electrical fields are capable of interfering with the proper
performance of the equipment. For this reason make sure that all external devices
operated in the vicinity of the equipment comply with the relevant EMC
requirements. Mobile phone, X-ray equipment or MRI devices are a possible
source of interference as they may emit higher levels of electromagnetic radiation.
z Before connecting the equipment to the power line, check that the voltage and
frequency ratings of the power line are the same as those indicated on the
equipment’s label or in this manual.
z Always install or carry the equipment properly to avoid damage caused by drop,
impact, strong vibration or other mechanical force.
z Dry the equipment immediately in case of rain or water spray.
1.1.3 Notes
NOTE
z Put the equipment in a location where you can easily view and operate the
equipment.
z The equipment use a mains plug as isolation means to the mains power supply. Do
not locate the equipment in a place difficult to operate the mains plug.
z In normal use, the operator shall stand in front of the equipment.
z Keep this manual in the vicinity of the equipment so that it can be obtained
conveniently when needed.
z The software was developed in compliance with IEC60601-1. The possibility of
hazards arising from software errors is minimized.
z This manual describes all features and options. Your equipment may not have all
of them.
To Next Page
Loading...
