3-8
3.9 Changing General Settings
This chapter covers only general settings such as language, brightness, date and time, etc.
Measurement settings and other settings can be referred to in respective sections.
3.9.1 Setting up a Monitor
In situations where you install a patient monitor or change the patient monitor’s application
site, you need to setup the patient monitor as follows:
1. Select [Main Menu][Maintenance >>][User Maintenance >>]enter the
required password.
2. In the [User Maintenance] menu, select, in turn, [Monitor Name], [Department] and
[Bed No.], and then change their settings.
3.9.2 Changing Language
1. Select [Main Menu][Maintenance >>][User Maintenance >>]enter the
required password.
2. In the [User Maintenance] menu, select [Language] and then select the desired
language.
3. Restart the patient monitor.
3.9.3 Adjusting the Screen Brightness
1. Select the [Main Menu][Screen Setup >>][Brightness].
2. Select the appropriate setting for the screen brightness. 10 is the brightest, and 1 is the
least bright.
If the patient monitor operates on battery power, you can set a less bright screen to prolong
the operating time of the battery. When the patient monitor enters standby mode, the screen
will change to the least brightness automatically.
To Next Page
Loading...
