Mitsubishi C70

2. CNC Monitor Screen
2.5 Program
I - 102
(3) MDI data setting
Enter MDI data by pressing the
data keys in sequence according
to the machining program listing.
N1 G28 X0 Y0 Z0 ;
N2 G92 X0 Y0 Z0 ;
N3 G00 X−100. Y−100. ;
N4 G01 X−300. F2000;
N5 Y−300. ;
N6 X−100. ;
N7 Y−100. ;
N8 M02 ;
Press the [INPUT] key.
1) The data is written into the MDI memory area.
2) It is displayed on every line per block.
3) The message MDI SETTING COMPLET is
displayed and MDI operation is enabled. The
running start position is the starting block of data.
The cursor is displayed in the starting block.
CAUTION
Because of key chattering, etc., during editing, "NO NOS. FOLLOWING G" commands become a
"G00" operation during running.
(Note 1) If the [INPUT] key is not pressed, data is simply displayed on the screen and is not actually
stored in memory. Be sure to press the [INPUT] key.
(Note 2) See “2.5.3 Program Edit Operation” for details of key operation to set MDI data.
(Note 3) Check the MDI SETTING COMPLET message before starting MDI operation. If the EDITING or
MDI NO SETTING message is displayed, MDI operation cannot be started. If the [INPUT] key is
pressed at the time, the MDI SETTING COMPLET message is displayed.
(1)
(2)