2. CNC Monitor Screen
2.5 Program
I - 123
(Note 1) The message "NO CHARACTERS" appears on the screen if the word cannot be found in the
designated direction. If the same menu key is pressed, the search starts again from the top for
the downward search and from the end of the program for the upward search.
(Note 2) Matching is checked within the No. of designated character strings, regardless of the character
strings before and after the ones designated. For example, even if G2 is designated, the
character strings such as G20 to G29, G200 onward, etc., become search targets.
(Note 3) During the character string search, macro statements are not handled as one word data, so the
operation differs from the usual character string search. For example, if "GO" is designated for
"GOTO" and a character string search is executed, the cursor is placed at [GOTO].
(Note 4) If a word character is entered for the search data after the menu key is pressed, the search
buffer is cleared and then the character is entered.
(Note 5) The search data is valid until ";" (EOB). Only one block can be searched at a time.
(Note 6) The [C.B] and [INS] keys are invalid for the search menu.
To Next Page
Loading...
Need help?
General
