6. CNC Data Input/Output
6.16 Various Status
III - 58
[Displayed messages (for errors)]
Message Error details
Unable to exec : PLC built in CNC running Stop PLC running in the CNC and try again.
USB drive has been stopped. USB drive has failed to stop. USB drive cannot be
removed.
Unable to exec : Program running Automatic operation is being executed. Stop the
operation and try again.
Out of memory Memory capacity was exceeded.Ensure sufficient
free space by deleting machining programs and try
again.
The same name exists. Attempting to create a directory is failed as the same
name exists. Input a different name.
In sampling Cannot input or output as it is in sampling.
Stop sampling and try again.
File not found The specified file does not exist in the copy
source.Check the settings and try again.
Timeout Communication with CNC failed. Check the
connection.
Can't create a directory A directory cannot be created. One of the
followings is the reason.
- The device is set to "CNC".
- Cannot write in a memory card.
- When outputting the batch file related to the cycle
monitor, a serial number 99 exists (exmaple:
"SAMP09012399" directory exists for January 23rd,
2009) so that a directory cannot be created. Transit
to the different directory or delete the directory.
Directory illegal The specified directory is illegal.Check the settings
and try again.
Check the restrictions about directory name and file
name on "3.17 Restrictions".
Data protect The data is protected.Check the functions such as
data protection key, edit lock and read only, and then
try again.
No. of registration over The number of registered programs was exceeded.
Delete unnecessary machining programs and try
again.
Pass is too long Pass is too long. Check the directory/file name.
File is not specified [Execute] is pressed without any file specified.
Specify a file and try again.
Some error found in file system File system error occurred. Format the NC memory.
To Next Page
Loading...
Need help?
General
