6. CNC Data Input/Output
6.16 Various Status
III - 60
[Error details]
Message Error details
Format Error Format is incorrect.
Range Over Value is incorrect.
In sampling Data cannot write as it is in sampling.
In this situation, a parameter number and a line number will not
be displayed.
Superposition
waveform cannot be
set.
"Superposition" parameter for cycle monitor is set to "NO" when
inputting the second waveform or it is judged that the
superposition is not possible compared with the parameter of the
first waveform.
Check the parameter settings, or input data.
[Messages displayed for confirmation windows]
Message Details
Start copying. Displayed in the copy confirmation window.
Start deleting. Displayed in the delete confirmation window.
Start deleting all programs. Displayed in the delete confirmation window when
ALL.PRG is selected.
OK? Displayed in the copy confirmation window and the delete
confirmation window.
The same file exists.
Do you want to overwrite?
Displayed in the overwrite confirmation window (for a
single file).
Restart the CNC. Displayed in the message window after SRAM.BIN has
been copied.
Program No. duplicate
Do you want to overwrite?
Displayed in the overwrite confirmation window (for
multiple machining programs).
Do you want to stop USB drive? USB drive enters the stopped state.
To Next Page
Loading...
Need help?
General
