Mitsubishi C70 User Manual

IV - 56
Appendix 7. Explanation of Alarms
Appendix 7.2 Stop Codes (T)
T01 Cycle start prohibit 0142
Details
In manual coordinate system setting
Automatic start is not allowed during the manual coordinate system setting.
Remedy
The system restarts after either of the manual coordinate system setting completion signal
or the error end signal has been turned ON.
T01 In manual measurement 0143
Details
Automatic start is disabled because manual measurement is in execution.
Remedy
- Execute automatic start after the manual measurement is completed.
T01 Cycle start prohibit 0180
Details
Automatic start became disabled while servo auto turning is enabled.
Remedy
- Set "#1164 ATS" to "0" when the servo auto turning is not executed.
T01 Cycle start prohibit 0190
Details
Automatic start is not possible because the setting of setup parameters is enabled.
Remedy
- Refer to the manual issued by the machine tool builder.
T01 Cycle start prohibit 0191
Details
Automatic start was attempted while a file was being deleted/written.
Remedy
- Wait for the file to be deleted/written and then execute the automatic start.
T01 Cycle st. prohibit (Term exp'd) 0193
Details
Automatic start is not possible because the valid term has been expired.
Remedy
- Enter the decryption code and turn the power ON again.
T02 H/W stroke end axis exists 0201
Details
An axis is at the stroke end.
Remedy
- Manually move the axis away from the stroke end limit switch.
- Correct the machining program.
T02 S/W stroke end axis exists 0202
Details
An axis is at the stored stroke limit.
Remedy
- Manually move the axis.
- Correct the machining program.

Mitsubishi C70 Specifications

General

Brand	Mitsubishi
Model	C70
Category	Control Unit
Language	English