2. CNC Monitor Screen
2.2 Monitor
I - 22
(3) Action to be taken when an erroneous numeric is set and the correct one is desired to be set
There are two methods:
Method (1) While pressing the [DEL] key, delete the set digits one by one. Then, retry to
enter the correct digits.
Method (2) Retry the entry, beginning with pressing the address key corresponding to the
command.
(Example) In this condition, the numeric is desired to be replaced by S1500.
Method (1)
Press [DEL] [DEL] [DEL] to delete
the
erroneously set numeric.
Enter [5] [0] [0] .
Method (2)
Press address key [S] to return to the
initial status.
Enter [1] [5] [0] [0] .
(4) Setting/output range of manual numeric command
The setting and output range for the manual numeric command are indicated.
BCD Signed binary
M 0~9999
S ±99999
T 0~9999
To Next Page
Loading...
