Mitsubishi C70 User Manual

IV - 166
Appendix 7. Explanation of Alarms
Appendix 7.12 Program Errors (P)
P171 NO G10 SPEC
Details
Compensation data input by program (G10) was commanded though it is out of
specifications.
Remedy
- Check the specifications.
P172 G10 L-No. ERR
Details
An address of G10 command is not correct.
Remedy
- Correct the address L No. of the G10 command.
P173 G10 P-No. ERR
Details
The compensation No. at the G10 command is not within the permitted number of sets in the
specifications.
Remedy
- Check the number of sets for the tool compensation Nos. and correct the address P
designation to be within the number of sets.
P174 NO G11 SPEC
Details
Compensation data input by program cancel (G11) was commanded though there is no
specification of compensation data input by program.
Remedy
- Check the specifications.
P177 LIFE COUNT ACT
Details
Registration of tool life management data with G10 was attempted when the "usage data
count valid" signal was ON.
Remedy
- The tool life management data cannot be registered during the usage data count. Turn the
"usage data count valid" signal OFF.
P178 LIFE DATA OVER
Details
The number of registration groups, total number of registered tools or the number of
registrations per group exceeded the range in the specifications.
Remedy
- Correct the number of registrations.

Mitsubishi C70 Specifications

General

Brand	Mitsubishi
Model	C70
Category	Control Unit
Language	English