Mitsubishi C70 User Manual

IV - 169
Appendix 7. Explanation of Alarms
Appendix 7.12 Program Errors (P)
P202 BLOCK OVR (MRC)
Details
The number of blocks in the shape program of the compound type fixed cycle for turning
machining I is over 50 or 200 (the maximum number differs according to the model).
Remedy
- Set a 50/200 or less value for the number of blocks in the shape program called by the
compound type fixed cycle for turning machining I commands (G70 to G73). (The
maximum number differs according to the model).
P203 CONF. ERR (MRC)
Details
A proper shape will not obtained by executing the shape program for the compound type
fixed cycle for turning machining I (G70 to G73).
Remedy
- Correct the shape program for the compound type fixed cycle for turning machining I (G70
to G73).
P204 VALUE ERR (MRC)
Details
A command value of the compound type fixed cycle for turning machining (G70 to G76) is
illegal.
Remedy
- Correct the command value of the compound type fixed cycle for turning machining (G70
to G76).
P210 NO PAT CYC SPC
Details
A compound type fixed cycle for turning machining II (G74 to G76) command was
commanded though it is out of specifications.
Remedy
- Check the specifications.
P220 NO SPECIAL CYC
Details
There are no special fixed cycle specifications.
Remedy
- Check the specifications.
P221 NO HOLE (S-CYC)
Details
"0" has been specified for the number of holes in special fixed cycle mode.
Remedy
- Correct the program.
P222 G36 ANGLE ERR
Details
A G36 command specifies "0" for angle intervals.
Remedy
- Correct the program.

Mitsubishi C70 Specifications

General

Brand	Mitsubishi
Model	C70
Category	Control Unit
Language	English