2. CNC Monitor Screen
2.3(I) Tool Offset (L system)
(Refer to "2.3 (II). Tool Offset (M system)" for Machining center system)
I - 62
3) Deleting a group registration
The group being displayed and its data can be deleted by pressing [SHIFT] + [C.B CAN] + [INPUT] .
4) Registering tools
Set the tools in order from the first tool to be used. If multiple compensation Nos. are used with one
tool, set the tool No. and respective compensation Nos. for each compensation No.
• Tool No. : Set the tool No. (1 to 999999: differs according to the specifications)
• Compensation No. : Set the compensation No. (1 to 80: differs according to the
specifications)
• USED : When the designated tool is other than a not-used tool, the initial
incrementation value can be adjusted by setting the USED data.
If no data is set, this value becomes 0. (Can be omitted.)
• ST : Designate whether the tool is a tool skip tool or not. (Can be omitted.)
If the data is not set, or if 0 to 2 is set, the data will be automatically set
according to the relation with the USED data and LIFE data.
0: Not used tool 1: Current tool (tool being used)
2: Normal life-reached tool 3: Tool skip tool
(Example) Setting to use multiple compensation Nos. with one tool.
# Tool No. Compensation No.
1 520000 11 ..... Equivalent to a T52000011 command.
2 520000 12 ..... Equivalent to a T52000012 command.
3 520000 13 ..... Equivalent to a T52000013 command.
(Note) Tool life management is carried out in group units with this function. Thus, if a tool is set in
a different group, the life will be managed according to the respective group, and that tool
cannot be managed correctly.
5) Deleting a tool registration
Set 0 in the tool No. of the # No. to be deleted. All data of that # No. will be deleted, and the
subsequent # Nos. and data will all move up a line.
To Next Page
Loading...
Need help?
General
