C-8
FX Series PLC User's Manual - Data Communication Edition
Parallel Link
1 Outline
1.4 Programming Tool Applicability
1.4.2 For non-applicable versions (setting an alternative model)
Even software not applicable to a PLC can create programs when an alternative model is set.
In this case, however, programming is enabled only in the function ranges provided for the alternative PLC
model such as instructions and program size.
*1. "FX
2N" is selected when the FX-10P is used.
Model to be
programmed
Model to be set Priority: High → Low
FX
3UC Series FX3UC → FX2N → FX2(FX)
FX
3U Series FX3UC, FX3U → FX2N → FX2(FX)
FX
3G Series FX3G →
FX
1N
*1
→
FX
2N
*1
FX2NC Series FX2NC, FX2N → FX2(FX)
FX
2N Series FX2N → FX2(FX)
FX
1NC Series FX1NC, FX1N → FX2N → FX2(FX)
FX
1N Series FX1N → FX2N → FX2(FX)
FX
1S Series FX1S → FX2(FX)
FX
0N Series FX0N → FX2(FX)
FX
0S Series FX0S → FX2(FX)
FX
0 Series FX0 → FX2(FX)
FX
2C Series FX2C, FX2(FX) → FX2(FX)
FX
2(FX) Series FX2(FX)
FX
1 Series FX1
To Next Page
Loading...
Need help?
General
