A-60
FX Series PLC User's Manual - Data Communication Edition
Common Items
3 Outline of Communication Setting in the FX Series
3.3 Communication Setting in Parameter Method (FXGP/WIN)
3.3.2 Correspondence between parameter setting and each communication type
The table below shows the communication types and items which can be set using parameters:
Set item Contents
CC-Link network
N:N Network
Parallel link
Computer link
Inverter communication
Non-protocol communication (RS instruction)
Non-protocol communication (FX2N-232IF)
Short mail sending
Internet mail sending
CC-Link/LT network
AS-i system
Programming communication
Remote maintenance
Remarks
Protocol
Non-protocol
communication
This communication is not executed in this setting.
This communication is not executed in this setting.
This communication is not executed in this setting.
—
This communication is not executed in this setting.
This communication is not executed in this setting.
This communication is not executed in this setting.
This communication is not executed in this setting.
This communication is not executed in this setting.
This communication is not executed in this setting.
Dedicated protocol —— —
Data length
7-bit —
8-bit
Parity
None
Odd —
Even —
Stop bit
1-bit
2-bit —
Baud rate (bps)
19200 —
9600
4800 —
2400 — —
1200 — —
600 — —
300 — —
Header Invalid/valid — — —
Terminator Invalid/valid — —
Control cable Invalid/valid — — —
Hardware type
Regular/RS-232C —
RS-485 —
Control mode Invalid — — — — Not selectable
Sum check Invalid/valid —— —
Transmission control
procedure
Format 1 —— —
Format 4 —— —
Station number settings 00 to 0F —— —
Time-out time setting
1 to 255 — —
Reference page — B C D E F G — — — — H I
To Next Page
Loading...
Need help?
General
