9 Positioning Control
9.12 Reciprocal movement insutruction (Ver.1.10 or later)
189
FX3U-20SSC-H Positioning Block User's Manual
1
Introduction
2
System
configuration
3
Example
Connection
4
Installation
5
Wiring
6
Memory
configuration
and data
7
Before starting
positioning
control
8
Manual control
9
Positioning
Control
10
Table Operation
2. Operation speed
The actual operation speed is decided by the following calculation formulas.
- Operation speed1 × Override setting
- Operation speed2 × Override setting
The actual operation speed 1 and operation speed 2 can be changed using the operation speed change
function except under the following conditions.
→ For change of the operation speed, refer to Section 7.6
• During deceleration operation
• When the speed change disable during operation signal is ON.
3. Address specification
Specified address are handled as absolute address.
(The absolute/relative address specification is ignored.)
4. Rotation Direction
The rotation direction is determined by the relationship among the current address, target address 1 and
target address 2.
To Next Page
Loading...
