10 Table Operation
10.1 Outline of Table Operation
190
FX3U-20SSC-H Positioning Block User's Manual
10. Table Operation
10.1 Outline of Table Operation
This section describes the table information setting and table operation motions.
For details on the positioning commands available with the table operation, refer to the following.
→ For details on each positioning operation, refer to Chapter 9
About the table operation
The "table operation" executes preset positioning operation patterns from the table information. Positioning
operations are consecutively executed and may be arranged in any order. A few positioning operations are
only available in table operation.
Positioning operations for table operation only
• Multi-speed operation
• Circular interpolation
• Continuous pass operation
10.1.1 Applicable positioning operations for table operation
*1. When interpolation operations are consecutively repeated in a table operation, the 20SSC-H provides
continuous pass operation.
→ For details on continuous operation, refer to Section 10.10
10.1.2 Types of table information and number of registered tables
• Applicable positioning operations for table
operation
• Inapplicable positioning operations for table
operation
- 1-speed positioning operation
- Interrupt 1-speed constant quantity feed
- 2-speed positioning operation
- Interrupt 2-speed constant quantity feed
- Interrupt stop
- Multi-speed operation
- Linear interpolation
*1
- Linear interpolation (interrupt stop)
*1
- Circular interpolation
*1
- Mechanical zero return
- Variable speed operation
- Manual pulse generator
- JOG operation
- Reciprocal movement instruction
(Ver.1.10 or later)
Type of table information Number of registered tables Table number
X-axis table information 300 tables 0 to 299
Y-axis table information 300 tables 0 to 299
XY-axis table information 300 tables 0 to 299
To Next Page
Loading...
