Mitsubishi FX3U-20SSC-H User Manual

3 Specifications
3.5 Pin Configuration
25
FX3U-20SSC-H Positioning Block User's Manual
1
Introduction
2
System configuration
3
Example Connection
4
Installation
5
Wiring
6
Memory configuration and data
7
Before starting positioning control
8
Manual control
9
Positioning Control
10
Table Operation
3.5 Pin Configuration
3.5.1 Input connector
Caution
The pin array is seen from the connection side (aperture side) of the input connectors of the 20SSC-H.
The pin numbers and the position of vary depending on the connectors for user cables.
Perform proper wiring while paying attention to the position of notches and the direction of connectors.
Otherwise, the product may be damaged due to wiring mistakes.
3.5.2 Power supply connector
Term inal
name
Description
Terminal
name
Description
X-INT0 Interrupt input (for X axis) Y-INT0 Interrupt input (for Y axis)
NC Not used NC Not used
X-INT1 Interrupt input (for X axis) Y-INT1 Interrupt input (for Y axis)
X- φ A+
Input terminal for A-phase input
of the manual pulse generator
(2-phase pulse) (for X axis)
Y- φ A+
Input terminal for A-phase input
of the manual pulse generator
(2-phase pulse) (for Y axis)
X- φ A-
Common terminal for A-phase
input of the manual pulse
generator (2-phase pulse)
(for X axis)
Y- φ A-
Common terminal for A-phase
input of the manual pulse
generator (2-phase pulse)
(for Y axis)
X- φ B+
Input terminal for B-phase input
of the manual pulse generator
(2-phase pulse) (for X axis)
Y- φ B+
IInput terminal for B-phase input
of the manual pulse generator
(2-phase pulse) (for Y axis)
X- φ B-
Common terminal for B-phase
input of the manual pulse
generator (2-phase pulse)
(for X axis)
Y- φ B-
Common terminal for B-phase
input of the manual pulse
generator (2-phase pulse)
(for Y axis)
X-DOG
Near-point DOG input terminal
(for X axis)
Y-DOG
Near-point DOG input terminal
(for Y axis)
S/S
Power input terminal (START,
DOG, INT0 and INT1) 24VDC
Pins that have the same name
(S/S) are shorted inside.
S/S
Power input terminal (START,
DOG, INT0 and INT1) 24VDC
Pins that have the same name
(S/S) are shorted inside.
X-START START input terminal (for X axis) Y-START START input terminal (for Y axis)
Connector pin array (aperture side)
Y-INT0
X-INT0
NC
NC
Y-INT1
X-INT1
Y-
A+
X-
A+
Y-
A-
X-
A-
Y-
B+
X-
B+
Y-
B-
X-
B-
Y-DOG
X-DOG
S/S
S/S
Y-START
X-START
3 Grounding (Green)
2 − (Black)
1 + (Red)

Mitsubishi FX3U-20SSC-H Specifications

General

Brand	Mitsubishi
Model	FX3U-20SSC-H
Category	Controller
Language	English