Mitsubishi FX3U-20SSC-H - Page 302

296
FX 3U -20SSC-H Positioning Block User's Manual
Revised History
1/2010 F • Supported in Ver.1.30
- When the absolute position detection system is used, ring operation allows
unlimited length feed. [Section 7.8]
- The contents of setting of the regenerative brake option are added. [Subsection
11.2.1]
- The continuous pass operation with m code (with mode) is changed. [Section
10.10]
• Timing at which the set data becomes valid. [Sections 6.2, 11.1, 11.2, 11.4 and 11.5]
• The contents of description are reviewed. [Sections 5.3, 6.2 and 6.3 and Chapters 7,
8, 9 and 10]
• User's Manual errors corrected.
12/2010 G • Supported in Ver.1.40
- Servo parameters are added [Sections 11.2 and Appendix A-5]
- Error codes are added [Subsection 13.2.3]
- Servo warning code is added [Subsection 13.2.4]
• MR-J3W- B is added
• MR-J3- BS is added
• User's Manual errors corrected.
7/2011 H • User's Manual errors corrected.
11/2011 J • Wiring precaution description expanded and corrected.
• User’s Manual errors corrected.
Date Revision Description