Mitsubishi FX3U-20SSC-H - Page 72

7 Before Starting Positioning Operation
66
FX3U-20SSC-H Positioning Block User's Manual
7.1 Note on Setting Parameters
From the previous page From the previous page
M380 M384
FNC 40
ZRST
D286 D287
FNC 40
ZRST
T14
Reads the operation
command 2 (X-axis) in
unit No. 1.
Resets the system reset
command in unit No. 1.
RST D286.1
D286 U1\G519
FNC 12
MOV
Sets (writes) the operation
command 2 (X-axis) in
unit No. 1. Executes
system reset.
U1\G519 D286
FNC 12
MOV
D290 D291
FNC 40
ZRST
SET M385
FNC 02
SRET
END