Mitutoyo SJ-301 - Page 111

5 - 13 No. 99MBB091A
5. MODIFYING THE MEASUREMENT CONDITIONS
■ Cutoff length (c) and traversing speed
The following traversing speeds can be selected for the cutoff lengths.
c
deepsgnisrevarT
)"300.(mm80.0)s/"10.(s/mm52.0
)"10.(mm52.0)s/"10.(s/mm52.0
)"30.(mm8.0)s/"20.(s/mm5.0,)s/
"10.(s/mm52.0
)"1.(mm5.2)s/"20.(s/m5.0
)"3.(mm8)s/"20.(s/m5.0
TIP If the cutoff length is set to 0.8 mm, either 0.5 mm/s or 0.25 mm/s can be selected
as the traversing speed. For more information refer to section 5.8, “Modifying the
Traversing Speed”.
■ Transition of screens if the cutoff length (c) is switched
Cut-off Length Setup window
[c]
Title bar
[Condition]
[Home]
Condition menu
STAND.
PROFILE
FILTER
N
c
RE-CAL
JIS'94
R
GAUSS
0.8mm
5
AUTO,ESC
0.25mm/s
ON
Page1/2
Measurement Condition Setup screen
Home screen
Condition JIS1994 GAUSS
c 0.8mm 5
(AUTO)
RANGE
Ra
Ry
CAL.
1.54
7.41
2000-01-01
 m
 m
CARD
F1 F2 F3 F4
Ra
Ra
Ra
Ra
0.10
2.00
10.00
80.00
c
0.8
0.25
Ra 




0.02
0.08
2.5
8
N5
Condition menu
STAND.
PROFILE
FILTER
c
s
EVA-L
RE-CAL.
JIS'94
R
GAUSS
4.0mm
0.8mm
2.5m
Page1/3
TIP • If “MOTIF.R” is selected as the measured profile, the icon indicating the cutoff
length changes from [c] to [A].
• If “MOTIF.W” is selected as the measured profile, the icon indicating the cutoff
length changes from [lc] to [B].
• If assessed profile MOTIF.R/MOTIF.W is selected, the display content changes
from icon [N] that indicates the number of sampling lengths to icon [L] that sets
the evaluation length to an arbitrary length.
NOTE Only if the R profile in JIS ’94 Standard is selected, ls can be set to None.