Mitutoyo SJ-301 - Page 144

5 - 46 No. 99MBB091A
■ Setting up mrd calculation condition
F1 F2 F3 F4
4 5 6
7
12
BS
AC
8 9
1 2
0 .
3
ESC
Rmr
(1 12)
N
 m
<Home screen>
CAL.
2000-01-01
CARD
Condition JIS1994 GAUSS
c 0.8mm  5
(AUTO)
RANGE
Ra
Rmr
(
10%,10.0m
)
****
****
%
 m
<Home screen>
CAL.
2000-01-01
CARD
Condition JIS1994 GAUSS
c 0.8mm  5
(AUTO)
RANGE
Ra
Ry
****
****
 m
 m
4
1
[Parameter scroll]
2
Parameter button
3
Section number button
<mr Measurement Condition Setup window>
Ra
Ry
CAL.
1.83
7.1
2000-01-01
 m
CARD
Condition JIS1994 GAUSS
c 0.8mm  5
(AUTO)
RANGE
Rmr
12
10
10.0
N
REF.LINE
S.LEVEL
%
m
Section number input field
[Enter]
<Section Number Input screen>
F1 F2 F3 F4
F1 F2 F3 F4
Touch the [Parameter scroll] button in the Home screen one
or more times until the parameter (mr) appears in the button,
for which the calculation condition is to be set.
Multiple number of parameters (mr) are displayed. If the
calculation condition is set for one mrd, it will be applied to
all mr parameters.
Touch the displayed parameter button.
The mr Measurement Condition Setup window will
appear.
Touch the section number button.
The Section Number Input screen will appear.
Enter the number of sections in the section number input field,
then touch the [Enter] button.
The input range is as follows:
1 to 12
TIP For information about inputting numeric values
refer to “■ Inputting numeric values” in section
2.2, “Outline of the Touch Panel”.
Returns to the mr Measurement Condition Setup window.