Mitutoyo SJ-301 - Page 190

No. 99MBB091A 7 - 4
Statistics
Ra
MIN
2.00
MAX
4.00
50
0.20
GO/NG
PAR A
INTER.
TOL.
NUM
ESC
<Statistical Measurement Results screen>
5
6
7
<Statistical Condition Setup screen>
[Enter]
<Statistical Measurement Results screen>
[START/STOP] Key
START
STOP
[START/STOP] Key
START
STOP
(050)
CANCEL
CLR
ESC
Statistics JIS1994 GAUSS
c 0.8mm 5
(AUTO)
RANGE
Ra
2000-01-01
(050)
CANCEL
2.83
3.00
3.10
CLR
ESC
Statistics JIS1994 GAUSS
c 0.8mm 5
(AUTO)
RANGE
Ra
2000-01-01
 m
 m
 m
[CANCEL] [CLR] [Enter]
On the Statistical Condition Setup screen the operator can
make modifications to any of the statistical conditions except
the number of samples as required.
TIP For information about modifying the statistical
conditions refer to section 7.3, “Settings Re-
lated to Statistical Processing”.
To accept the statistical conditions touch the [Enter] button.
The Statistical Measurement Results screen will appear.
Perform measurement with this screen. Press the [START/
STOP] key to start.
This operation performs measurement and displays the
result on the screen.
Continue measurement by pressing the [START/STOP] key.
If the set number of sample data has been obtained,
statistical processing will automatically take place and the
Statistical Processing Results screen will appear.
NOTE • Touching the [CANCEL] button erases the
latest measurement data.
• Touching the [CLR] button displays a mes-
sage to comfirm whether to erase all the
measurements so far obtained. Touch the
[ENTER] button to execute erasing all the
measurement data.
• If the [Enter] button is touched after at least
one measurement session has been per-
formed, statistical processing will be con-
ducted based on the measurements results
obtained up to that point in time, and the
result will be displayed. If no measurement
session has been performed yet, statistical
processing will not be conducted.