Mitutoyo SJ-301 - Page 222

No. 99MBB091A 8 - 22
● About the [UNDO] function
The Select File window, which is displayed when the [CONDITION READ] key is pressed,
features the [UNDO] button.
F1 F2 F3 F4
<File Select window>
Condition JIS1994 GAUSS
c 0.8mm 5
(AUTO)
RANGE
Ra
Ry
CAL.
1.83
7.12
2000-01-01
 m
 m
CARD
COND3
Condition READ
COND1
COND4
COND2
COND5 UNDO
[UNDO]
The [UNDO] button provides the following two functions.
• If the measurement conditions were read from the internal memory using the [CONDI-
TION READ] key, this button restores the screen to its previous condition (condition
before the measurement conditions were overwritten).
TIP Refer to “■ How to read measurement conditions with the [CONDITION READ] key”
described previously.
• If any of the measurement conditions have been modified in the Measurement Condition
Setup screen, perform the following procedure to restore the previous conditions.
F1 F2 F3 F4
Condition JIS1994 GAUSS
c 0.8mm 5
(AUTO)
RANGE
Ra
Ry
CAL.
1.83
7.12
2000-01-01
 m
 m
CARD
COND3
Condition READ
COND1
COND4
COND2
COND5 UNDO
Condition JIS1994 GAUSS
c 0.8mm 5
(AUTO)
RANGE
Ra
Ry
CAL.
1.54
7.41
2000-01-01
 m
 m
CARD
<Home screen>
CONDITION
READ
1
[CONDITION READ] key
2 <File Select window>
Title bar
[UNDO]
F1 F2 F3 F4
When the Home screen is active, press the [CONDITION
READ] key on the Display Unit.
The File Select window will appear.
Touch the [UNDO] button then touch the title bar.
The measurement conditions before the modification are
restored and then the Home screen is returned to.