Mitutoyo SJ-301 - Page 26

No. 99MBB091A 2 - 6
IMPORTANT Observe the following precautions when operating the touch panel. Otherwise, the
touch panel might be damaged.
• Do not push the touch panel too hard.
• Do not operate the touch panel using a sharp-tipped object such as a ball-point
pen.
• Do not touch the touch panel with contaminated fingers. To avoid contamination
on the touch panel, use the touch pen. Insert the touch pen in the pen holder
when not in use. Also, safe keep the touch pen in the compartment inside the
Display unit if it may not be used for long.
■ Buttons that load or cancel the setup content
The following types of screens and windows are displayed in the touch panel. The buttons
used to load or cancel the setup content of each screen/window are also explained.
● “XX screen”
The setup contents are loaded or cancelled with the [Enter] and [ESC] buttons.
Staistics
Ra
MIN
2.00
MAX
4.00
50
0.20
GO/NG
PARA
INTER.
TOL.
NUM
ESC
[Enter] button
Loads the setup conditions in the current screen and
updates the screen contents.
[ESC] button
Cancels the setup contents in the current screen and restores
the contents to their previous settings. The Home screen
may be restored depending on the situation.
[Home] button
Loads the setup conditions and returns to the Home screen
(Main screen).
● “XX window”
The setup contents are loaded by touching the title bar in the upper portion of the pop-up
window.
Condition menu
STAND.
PROFILE
FILTER
RANGE
SPEED
N
c
RE-CAL.
JIS'94
R
GAUSS
0.8mm
5
AUTO,ESC
0.25mm/s
ON
Page1/2
PROFILE
RP
DIN4776
MOTIF.R
MOTIF.W
Title bar
Loads the setup contents in the currently displayed window
and closes the window.
XX window
● “Error message window”
An error message is displayed if an error occurs during processing.
To close the error message window, touch the [OK] button.
Condition JIS1994 GAUSS
c 0.8mm 5
(AUTO)
RANGE
Ra
Ry
1.54
7.41
2000-01-01
 m
 m
S TAT. I /O
F1 F2 F3 F4
OK
PRINTER ERROR1
[OK] button
Closes the window.
Error message window