No. 99MBB091A
10 - 8
■ Adapter for height gage Nos. 12AAA222, 12AAA233
Used to secure the Drive/Detector unit to the height gage.
The height gage is used to set the height of the measuring position manually or if the
Drive/Detector unit can not be held by hand.
● Dimensions and application example
Unit : mm (inch)
A x B : 9 mm x 9 mm or 1/4" x 1/2"
A
55.5
(2.185")
21 (.827")
Adapter for height gage
Drive unit
Workpiece
Height gage
Nosepiece for flat surface
B
● Attaching the Adapter for the height gage
1. Attach the Adapter to the rear of the Drive unit.
2. Using the supplied Allen wrench tighten the two screws specified.
Drive unit
A
B
Adapter for height gage
No.12AAA222
(A x B = 9 x 9)
No.12AAA233
(A x B = 1/4" x 1/2")
Screws
Detector
To Next Page
Loading...
