13 - 21
No. 99MBB091A
13. SPECIFICATIONS
● Transfer data top specification and storage area specification write command
redaeHdleif-buSataDME
WRCAN 1*2*RC
Below are the contents of *1 and *2 in the data column above.
Data Bytes Description
*1 Start data point 5 ***** Specification of the leading data to be transmitted
by the RDDTA command.
*2 Specification of data storage area 2 ** 00: Measurement data 01: Evaluation data
Under the following conditions, except when using WRCAN command, the start data point is “1”.
• At power ON
• At the start of measurement
● Traversing length setting write command
redaeHdleif-buSataDME
WRTRA 1*RC
Below is the content of *1 in the data column above.
ataDsetyBnoitpircseD
gnitteshtgnelgnisrevarT1*1 levart-tsop/erpsedulcxE:1levart-tsop/erpsedulcnI:0
● Write command of evaluation length for MOTIF
redaeHdleif-buSataDME
WRML _ 1*RC
)H02(edocecapS:_
Below is the content of *1 in the data column above.
ataDsetyBnoitpircseD
htgneltimilreppuhcaerofshtgnelnoitaulavE1*71*****,*****,*****
To Next Page
Loading...
