No. 99MBB091A
3 - 4
■ Detaching the Detector
Gently pull the Detector straightforward from the Drive unit.
● Procedure when using the front escape type drive unit
1. Check that the detector is in the front escape state.
If the detector is escaped all the way to the front, advance to step 2.
Otherwise, turn on the power, press the [START/STOP] key to restore the front escape
state of the detector, and then turn off the power.
2. After confirming the orientation of both detector and drive unit connectors (pin positions),
gently and straightforward insert the detector into the drive unit hole.
Detector
Set the Detector with
the stylus facing down.
Connector view
Connector view Drive unit
■ Detaching the detector
Gently pull the detector straightforward from the drive unit.
To Next Page
Loading...
