4 - 17
No. 99MBB091A
4. MEASUREMENT OPERATION
■ Setting the display magnification (vertical and horizontal) of a measured profile
The display magnification of a measured profile can be set. It is convenient to compare the
measured profiles of multiple workpieces if the magnification is fixed.
NOTE The display magnification setting is synchronized with the printing magnification. If
the magnification setting is changed here, the printing magnification is also changed.
XZ
XZ
X
Z
ZX
AUTO(50K)
AUTO(50)
100 500200
10 5020
1K 5K2K
10K 50K20K
100K
Ver.
AUTO
[X-Mag]
Vertical magnification buttons
[Z-Mag]
Title bar
<Measured Profile screen (zoom-in)>
<Vertical Mag. Setup window>
<Horizontal Mag. Setup window>
Hor.
50
1 52
100 500200
AUTO
20
1K
10
Title bar
Horizontal magnification buttons
Touch the [Z-Mag] button in the zoomed-in display to open
the Vertical Mag. Setup window.
Touch the [X-Mag] button to open the Horizontal Mag. Setup
window.
After touching the desired vertical magnification button, touch
the title bar to load the magnification.
The Vertical Mag. Setup window closes, and the display
magnification in the Measured Profile screen (zoom-in) is
updated.
TIP If the [AUTO] button has been selected, a
vertical magnification suitable for printing is
automatically set up.
After touching the desired horizontal magnification button,
touch the title bar to load the magnification.
The Horizontal Mag. Setup window is closed and the
display magnification in the Measured Profile screen
(zoom-in) is updated.
TIP If the [AUTO] button has been selected, a
horizontal magnification suitable for printing is
automatically set up.
To Next Page
Loading...
