Mitutoyo SJ-301 - Page 94

No. 99MBB091A 4 - 28
■ Displaying the Printer Setup screen
If changing print conditions, display the Printer
Setup screen.
1 <Home screen>
2
<2nd Home screen>
3
<I/O Condition Setup screen>
<Printer Setup Screen>
Condition JIS1994 GAUSS
c 0.8mm 5
(AUTO)
RANGE
Ra
Ry
CAL.
1.54
7.41
2000-01-01
 m
 m
CARD
Condition JIS1994 GAUSS
c 0.8mm 5
(AUTO)
RANGE
Ra
Ry
1.54
7.41
2000-01-01
 m
 m
STAT. I/O
PRINTER
ITEM
PRINT
FORM
Ver.
Hor.
AUTO
AUTO
AUTO
ESC
F1 F2 F3 F4
F1 F2 F3 F4
I/O Menu
PRINTER
SELECT
SET
CARD
SET
SET
2
1
CARD
DATA
RS232C
MNT.
[SHIFT]
[I/O]
[Printer]
Touch the [SHIFT] button on the Home screen.
The 2nd Home screen is displayed.
Touch the [I/O] button.
The I/O Condition Setup screen is displayed.
Touch the [Printer] button.
The Printer Setup screen is displayed. The print conditions
which can be set in this screen are shown below.
• Print item (items to be printed)
• Print method (automatic print, manual print, and hard
copy)
• Print form (Portrait or Landscape).
• Vertical and horizontal magnifications (print magnifi-
cation of a measured profile)
The setting procedures are explained in the following pages.
NOTE If the print magnification (vertical and horizon-
tal) of a measured profile has been set, the
display magnification is updated to the same
value when the measured profile is displayed in
the touch panel.