Mitutoyo SJ-301 - Page 95

4 - 29 No. 99MBB091A
4. MEASUREMENT OPERATION
■ Selecting print items
PRINTER
ITEM
PRINT
FORM
Ver.
Hor.
AUTO
AUTO
AUTO
ESC
PRINTER
ITEM
PRINT
FORM
Ver.
Hor.
AUTO
AUTO
AUTO
ESC
PRINTER
ITEM
PRINT
FORM
Ver.
Hor.
AUTO
AUTO
AUTO
ESC
ITEM
COND. RES.
BAC1 ADCBAC2
MEMO
PRINTER
ITEM
PRINT
FORM
Ver.
Hor.
AUTO
AUTO
AUTO
ESC
ITEM
COND.
BAC1 ADCBAC2
MEMO
RES.
<Printer Setup screen>
<Print Item Select window>
<Print Item Select window>
<Printer Setup screen>
Item buttons
Title bar
[ITEM]
[Home] [ESC] [Enter]
1
2
3
Touch the [ITEM] button of the Printer Setup screen.
The Print Item Selection window is displayed.
Touch the button of the item to be set.
The definition of each item is given below.
COND.: Measurement condition RES.: Measured result
: Measured profile BAC1: BAC1 curve
BAC2: BAC2 curve ADC: ADC curve
MEMO: A memo, etc., appended to the printed matter.
(Input prior to printing.)
: Print save mode
TIP For an example of printout in the save mode,
refer to “■ Print format with the SJ-301 ● Print
in the print save mode” in section 4.5.1, “Print
method”.
Touch the title bar on the Print Item Selection window to load
the selected items.
The Print Item Selection window closes.
• Touching the [Home] button updates the print items and
the Home screen is restored.
• Touching the [Enter] button updates the print items and
the I/O Condition Setup screen is restored.
• Touching the [ESC] button cancels the new print items
and the I/O Condition Setup screen is restored.