• If for any of the Motorola alert tones, there is a counterpart in the folder with custom alert tones, the
custom alert tone is mapped instead of the Motorola alert tone.
As the result, the number of alert tones that can be available for dispatchers is 15 or less. The
available alert tones can be either Motorola alert tones or custom alert tones, or both types. In the Elite
Admin application, make them available for dispatchers by adding them to one of the toolbars in
the .elt configurations.
Another configuration that you perform by using the Elite Admin application is setting the transmission
methods for the available alert tones. Perform it by assigning the available alert tones to one of the
following categories:
Momentary
Alert tones that are sent only while the dispatcher presses the Alert Tone button on the toolbar in
the Elite Dispatch application.
Latched
Alert tones sent for a predefined time after the dispatcher presses the Alert Tone button on the
toolbar in the Elite Dispatch application. They can stop sending the latched alert tone before the
predefined time ends by pressing the Alert Tone button again.
See the MCC 7500/7100 Elite Admin User Guide manual.
Elite Dispatch Configuration and Operation
After you launch the Elite Dispatch application, the software automatically takes the following actions:
•
Obtains the Tone Pre-time Delay and the Alert Tone Talk Extend timers that you set up for the
system
• Uses the .elt file that you established in the Elite Admin application to determine which audio files
must be available for transmission
• Checks whether the available audio files conform to the format and specifications
• Enables properly configured audio files for use in the application
The Elite Dispatch software also compares the number of audio files available in the defined location
on the console client to the number of alert tones defined in the .elt configuration. If any of the audio
files specified in the .elt configuration are present in the defined localization, the corresponding Alert
Tone button is not available to the dispatcher.
To transmit an alert tone, the dispatcher clicks the Alert Tone Selector button or the corresponding
Alert Tone button in the Elite Dispatch application. The Alert Tone buttons are numbered accordingly.
If you configured the micro help text for the Alert Tone buttons, additional information about the alert
tone appears when you hover over the button.
For information about using alert tones in the Elite Dispatch application, see the MCC 7500/7100 Elite
Dispatch User Guide manual.
MN000672A01-E
Appendix B: Enhanced Alert Tones
Send Feedback 163
To Next Page
Loading...
Need help?
General