Motorola MC68HC908AB32 - Features; Introduction

Serial Peripheral Interface Module (SPI)
Technical Data MC68HC908AB32 — Rev. 1.0
280 Serial Peripheral Interface Module (SPI) MOTOROLA
16.13.3 SPSCK (Serial Clock). . . . . . . . . . . . . . . . . . . . . . . . . . . . .302
16.13.4 SS
(Slave Select) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .302
16.13.5 CGND (Clock Ground) . . . . . . . . . . . . . . . . . . . . . . . . . . . .303
16.14 I/O Registers. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .304
16.14.1 SPI Control Register. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .304
16.14.2 SPI Status and Control Register . . . . . . . . . . . . . . . . . . . .306
16.14.3 SPI Data Register. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .309
16.2 Introduction
This section describes the serial peripheral interface (SPI) module,
which allows full-duplex, synchronous, serial communications with
peripheral devices.
16.3 Features
Features of the SPI module include the following:
• Full-duplex operation
• Master and slave modes
• Double-buffered operation with separate transmit and receive
registers
• Four master mode frequencies (maximum = bus frequency ÷ 2)
• Maximum slave mode frequency = bus frequency
• Serial clock with programmable polarity and phase
• Two separately enabled interrupts:
– SPRF (SPI receiver full)
– SPTE (SPI transmitter empty)
• Mode fault error flag with CPU interrupt capability
• Overflow error flag with CPU interrupt capability
• Programmable wired-OR mode
•I
2
C (inter-integrated circuit) compatibility
• I/O (input/output) port bit(s) software configurable with pullup
device(s) if configured as input port bit(s)