Motorola MC68HC908AB32 User Manual

EEPROM
EEPROM Registers
MC68HC908AB32 — Rev. 1.0 Technical Data
MOTOROLA EEPROM 77
5.10.2 Stop Mode
The STOP instruction reduces the EEPROM power consumption to a
minimum. The STOP instruction should not be executed while the
programming and erasing sequence is in progress.
If stop mode is entered while EELAT and EEPGM is set, the
programming sequence will be stopped and the programming voltage to
the EEPROM array removed. The programming sequence will be
restarted after leaving stop mode; access to the EEPROM is only
possible after the programming sequence has completed.
If stop mode is entered while EELAT and EEPGM is cleared, the
programming sequence will be terminated abruptly.
In either case, the data integrity of the EEPROM is not guaranteed.
5.11 EEPROM Registers
Four I/O registers and three non-volatile registers control program,
erase, and options of the EEPROM array.
5.11.1 EEPROM Control Register
This read/write register controls programming/erasing of the EEPROM
array.
EEDUM — Dummy Bit
This read/write bit has no function.
Address: $FE1D
Bit 7 654321Bit 0
Read:
EEDUM
0
EEOFF EERAS1 EERAS0 EELAT AUTO EEPGM
Write:
Reset: 00000000
Figure 5-2. EEPROM Control Register (EECR)

Motorola MC68HC908AB32 Specifications

General

Brand	Motorola
Model	MC68HC908AB32
Category	Controller
Language	English